Teledyne LeCroy CA10-QUADPAK Offers

Intended for use with you Teledyne LeCroy oscilloscopes and motor drive analyzers, this adaptor allows you to use third-party current sensors with your Teledyne LeCroy instruments with full functionality. The programmable EEPROM saves third-party sensor parameters for easy access, and the interface provides automatic scaling in A/div.

Features

• Provides ability for third party current sensor to operate like a Teledyne LeCroy probe
• Programmable EEPROM saves third-party current sensor parameters for simple use
• Allows for addition of shunt resistor and RLC filter components
• Supports installation of physical hardware components, including shunt resistors and RLC bandwidth filter components, based on the requirements of your device
• ProBus Active interface supports automatic scaling in A/div to prevent manual entry errors and save time
• Programmable bandwidth filters include full BW, 200 MHz and 20 MHz
• Easy to use, saves time and possible errors

Measurement flexibility

Once this adaptor is programmed, the third party transducer/transformer will be recognized and operate like a Teledyne LeCroy probe.

Power of customization

This adaptor provides the ability to easily install physical hardware components such as shunt resistors and bandwidth filter components based on the requirements of the device being used. This adaptor also has programmable bandwidth limit filters of full BW, 200 MHz, or 20 MHz.

Easy to use

The programmable interface is intuitive and easy to use. Once this adaptor is configured, it will recognize the third party device with the correct scaling factors on any compatible Teledyne LeCroy oscilloscope or motor drive analyzer. This saves time and possible errors involved in manually entering scaling factors each time the device is connected.