This AC/DC current probe is designed for use with the AEMC 6292 Micro-ohmmeter.
This AC/DC current probe is designed for use with the AEMC 6292 Micro-ohmmeter.
This AC/DC is required for taking measurements in BSG (both sides grounded) mode with the 6292 and also has a proportional mV output for direct reading on the Micro-Ohmmeter.
Measurement Range | 1 to 50ADC |
Accuracy | 1 to 50ADC: 1.5% reading ± 0.2A |
Output Signal | 10mV/ADC |
Load Impedance | >100kΩ/100pF |
Insertion Impedance | 0.39mΩ @ 50Hz, 58mΩ @1000Hz |
Working Voltage | 600Vrms |
Influence of Adjacent Conductor | <10mA/A at 50Hz at 23mm from the probe |
Influence of Conductor in Jaw Opening | 0.5% reading |
Power Source | Powered by Micro-Ohmmeter Model 6292 |
Jaw Opening | 1.2" (31mm) |
Maximum Cable Diameter | One 1.18" (30mm) or two 0.95" (24mm) or two bus bars 1.2 x 0.4" (31.5 x 10mm) |
Output | 4-conductor shielded cable with 5-pin XLR connector |
Dimensions | 8.8 x 3.82 x 1.73" (224 x 97 x 44mm) |
Weight | 15 oz (440g) |
Saftey | EN 61010-2-32, 600V CAT III, Pollution: 2 |
Measurement Range | 1 to 50ADC |
Accuracy | 1 to 50ADC: 1.5% reading ± 0.2A |
Output Signal | 10mV/ADC |
Load Impedance | >100kΩ/100pF |
Insertion Impedance | 0.39mΩ @ 50Hz, 58mΩ @1000Hz |
Working Voltage | 600Vrms |
Influence of Adjacent Conductor | <10mA/A at 50Hz at 23mm from the probe |
Influence of Conductor in Jaw Opening | 0.5% reading |
Power Source | Powered by Micro-Ohmmeter Model 6292 |
Jaw Opening | 1.2" (31mm) |
Maximum Cable Diameter | One 1.18" (30mm) or two 0.95" (24mm) or two bus bars 1.2 x 0.4" (31.5 x 10mm) |
Output | 4-conductor shielded cable with 5-pin XLR connector |
Dimensions | 8.8 x 3.82 x 1.73" (224 x 97 x 44mm) |
Weight | 15 oz (440g) |
Saftey | EN 61010-2-32, 600V CAT III, Pollution: 2 |