TED5000 Installation and Troubleshooting Guide

This series of videos from The Energy Detective will help you install and troubleshoot your TED5000 Home Energy Monitor

Installing Your TED5000

Are you ready to start using your new TED system? Watch a short video that explains how to correctly install TED inside your breaker panel.

Setup and Troubleshooting Part 1: Accessing the Footprints Software

This is part one of the TED troubleshooting series, and also an introduction on how to start collecting data from your unit.
This video shows you how to ensure a successful connection to Footprints Software, which is embedded in your Gateway.

Setup and Troubleshooting Part 2: Changing Settings in the Footprints Software

This is part two of the TED troubleshooting series, and also an run down of how to control and change different parts of the Footprints software.
This video shows you how to set up your Footprints Software, including entering Product IDs and configuring TED solutions with multiple MTUs.

Setup and Troubleshooting Part 3: Powerline Carrier Signal

This is Part 3 of the TED Troubleshooting Series
This video focuses on Power Line Carrier signal (PLC), which is the communication method for the MTU sending information to the Gateway.

Setup and Troubleshooting Part 4: Inline and Wired Filters

This video shows you how to use filters to reduce noise in your home that may interfere with TED's Power Line Communication.